Hanmatek Dos1102 Manual

Any specific or behavioral glitches you are seeing.

: Front port for flash drives; rear port for direct PC connectivity. Initial Setup and Compensation

Wrong trigger level or probe not connected. Manual reference: Section on Probe Compensation and Auto Setup. Fix: Press the Auto Setup button. The scope automatically adjusts vertical, horizontal, and trigger settings. If that fails, press Trigger Menu and set the Type to Edge and Source to the channel in use (CH1 or CH2). Adjust the Level knob until a trigger indicator appears.

The 7-inch screen displays the waveform grid (graticule), status bars, and soft-menus. hanmatek dos1102 manual

Choose your desired parameters from the on-screen menu (e.g., Frequency, Peak-to-Peak Voltage, Period, RMS).

The scope forces a refresh of the screen even if it doesn't detect a trigger event. This is ideal for checking DC voltages or flatlines.

Understanding the numbers is key. Here is a table of the most important technical specifications for the Hanmatek DOS1102, pulled directly from the official manual and product pages. This will help you understand the scope's capabilities and limitations. Any specific or behavioral glitches you are seeing

If you're just getting started, here’s a quick-reference guide to your new scope: Dual Channels : 110MHz bandwidth with a 1GS/s sample rate.

Use the multi-purpose adjustment knob to move Cursor A and Cursor B. The screen will dynamically calculate and display (the voltage difference) or (the time difference, along with for frequency). Trigger Modes Explained

For precise control:

You must calibrate your probes before taking any accurate measurements. Improperly compensated probes introduce severe amplitude distortions and rise-time errors. Step 1: Power On and Reset

Go to the Channel menu and toggle Invert to OFF. If you have a specific question about: Probe Compensation steps FFT Analysis setup USB Data Export instructions Share public link