Click on the button and press P to open the Pick Devices dialog.
This is almost always an address mismatch or incomplete initialization. Use the I2C debugger to confirm the slave is acknowledging the address frame. If it's acknowledging, check that your initialization sequence includes the proper delay after power-up (at least 50ms) and that you're sending the correct command bytes (0x30, then 0x20 for 4-bit mode, then 0x28 for 2-line configuration).
Simulating the JHD-2X16-I2C in Proteus VSM requires specific drivers, often using the DFRobot_RGB_LCD1602 library, due to timing differences with standard hardware libraries. Crucially, the PCF8574 driver address in Proteus is generally 0x20, whereas physical hardware typically operates at 0x27 or 0x3F. For a practical demonstration on configuring this component, watch this tutorial jhd2x16i2c proteus exclusive
The default hardware mapping for a JHD2X16I2C module routes the 8-bit parallel output of the expander to the LCD pins as follows: →right arrow RS (Register Select) P1 →right arrow RW (Read/Write) P2 →right arrow E (Enable) P3 →right arrow Backlight Control Switch (Optional) P4 →right arrow D4 (Data Line 4) P5 →right arrow D5 (Data Line 5) P6 →right arrow D6 (Data Line 6) P7 →right arrow D7 (Data Line 7) Ground the unused data lines ( D0cap D sub 0 D3cap D sub 3
Download the custom files ( .idx and .lib ) from a trusted electronics resource. Close Proteus completely. Click on the button and press P to
Proteus Exclusive JHD2x16 I2C Ready
A common "deep" issue is the hex address. While real hardware might use 0x3F , Proteus simulation models often default to 0x20 or 0x27 . Key Components for Simulation For a practical demonstration on configuring this component,
32 characters in total, usually white text on a blue or green/yellow backlight.
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
To drive the Proteus simulation, use the following structured C++ code designed for the Arduino framework. It utilizes the LiquidCrystal_I2C library to handle the 4-bit data shifting transparently over the I2C bus.
#include <Wire.h> #include <LiquidCrystal_I2C.h>
