Ts1162 Installation Manual Exclusive

| Problem | Likely Cause | Solution | | :--- | :--- | :--- | | | Power not reaching the timer motor. | Check Line voltage. Ensure wires are connected to the correct Line terminals. | | Load does not turn on | Trippers are loose or missing. | Tighten tripper screws. Verify trippers are installed at the correct times. | | Switch stays ON constantly | Manual Override is engaged. | Move manual override switch to the "Auto" or center position. | | Switch hums loudly | Loose mounting or internal wear. | Ensure the unit is screwed tightly to the box. If noise persists, mechanism may need replacement. |

The TS1162 features an internal brush mechanism that automatically sweeps debris from the tape head path during loading and unloading sequences. ts1162 installation manual exclusive

: Always cut all AC and backup battery power to the main Challenger or Network Access Controller (NAC) panel before wiring any peripheral device. Working on a live RS-485 data bus can short out data lines or permanently damage the communication ports. | Problem | Likely Cause | Solution |

To complete installation, you must configure the Challenger system to recognize the newly mapped unit. | | Load does not turn on | Trippers are loose or missing

: Press the local RTE button to confirm the open-collector output fires and fires the door relay cleanly. 🔒 Manufacturer & Security Guidelines

Calculated using standard, unshielded twisted-pair data cabling. IP67 Weather-Rated

Configure the specific security areas that this keypad will arm, disarm, or access.