Manual |link|: Xycd60

) and opens (cuts off load) when the voltage falls to the lower limit ( 3. Setting Parameters To configure the module, use the following button sequence: Enter Setting Mode: Long press the Switch Parameters: Short press to cycle through parameters: (upper limit), (lower limit), and (time control). Adjust Values: buttons to increase or decrease values. Save and Exit: Long press for 5 seconds to save and return to the main interface. Switch Modes: Long press the button for 5 seconds to toggle between Charging ( ) and Discharging ( 4. Advanced Functions

Avoid running continuous loads right at the 10A limit to prevent the relay from overheating.

The is a dual-mode DC voltage controller (6V–60V) designed for automated battery charging and discharge protection. It is commonly used as a voltage-sensitive relay to prevent overcharging or deep discharge in 12V, 24V, and 48V systems. 1. Setup and Quick Guide

Short press the SET button to cycle between UP , dn , OP (Time), DOP (Display Delay). xycd60 manual

Press to save each value. Exit by holding SET or waiting 10 seconds.

Locate the terminals marked for power (often labeled L , N , and Ground or simply AC ).

: Connect the battery or power source to the VIN+ and VIN- terminals. ) and opens (cuts off load) when the

: When the battery voltage drops to or below the lower limit ( dn ), the relay closes, and IN flashes on the LCD to signal active charging. When the voltage reaches or exceeds the upper limit ( UP ), the relay snaps open, cutting off the charger. 2. Discharging Control Mode ( OUT )

Ensure correct polarity. Connecting the battery backward can damage the module. The input and output negative poles are linked, but the positive poles are separated by the relay [as per Scribd User Manual]. 6. Functional Operations (Button Functions)

Use this mode to connect a charger to a battery, cutting off power when the battery is full. Connect battery to input, charger to output. Save and Exit: Long press for 5 seconds

Given the ambiguity of the model number, here is a final guide to help you find the correct information:

The is a highly versatile, dual-mode battery charge and discharge controller module . Operating across a wide voltage range of DC 6V to 60V , it acts as an intelligent switch designed to protect lead-acid, lithium-ion, and LiFePO4 batteries from overcharging and deep discharging. Crucial Note before operating: The Go to product viewer dialog for this item.